Polaris Home
Polaris Home
Find a Retailer
SKU #F8050

Polaris 8050 Sport

Polaris 8050 Sport

Polaris 8050 Sport Spare Parts & Accessories

Polaris Robotic Pool Cover
R0785800

R0785800 Polaris Robotic Cleaner Cover

Protect your investment with a cover that fits over most Polaris Robotic models.

R0632700

R0632700 Fine Filter Canister

R0632701

R0632701 General Purpose Canister

R0632702

R0632702 Ultra Fine Sand/Slit Canister

R0632000

R0632000 Complete Motor Block C

R0632100

R0632100 Complete Floating Cable

Polaris 8050 Sport User Guides

Document ID SL6956
Description Polaris 8050 Sport Brochure
File Size 1.97 MB
|
File Type PDF
Document ID H0576900
Description Polaris 8050 Sport Robotic Pool Cleaner Owner's Manual
File Size 5.99 MB
|
File Type PDF
Document ID H0579700
Description Polaris 8050 Robotic Cleaner Quick Start Guide
File Size 6.02 MB
|
File Type PDF

Polaris 8050 Sport Frequently asked questions

There is too much cable length in the water. Do not unravel the entire cable length. Place only the required length of cable in the water and place the rest on the side of the pool. Follow the procedure in "Cord Tangling" in the manual to avoid and correct tangled cord.
  1. Unplug floating cable from the control unit and reconnect.
  2. Remove cleaner from the pool and re-submerge, see Submerging the Cleaner section of the Owner's Manual.
  3. Press power button OFF, then Floor/Wall setting button to begin a new cycle.
  4. Contact Polaris Technical Support at 1-800-822-7933 (USA); 1-888-647-4004 (Canada).
  1. Remove cleaner from the pool and re-submerge, see the Submerging the Cleaner section in the Owner's manual.
  2. Clean the filter canister, see Cleaning the Filter Canister in the Owner's Manual.
  3. Contact Polaris Technical Support at 1-800-822-7933 (USA); 1-888-647-4004 (Canada).
  1. Clean the filter canister, see Cleaning the Filter Canister in the Owner's Manual.
  2. Adjust Surface Control System™ setting, see the Wall Cleaning section in the Owner's Manual.
  3. Do a shock chlorination treatment to reduce the pH levels in the pool. DO NOT leave the cleaner in the pool during this treatment.
Remove cleaner from the pool and re-submerge, see the Submerging the Cleaner section in the Owner's Manual.
  1. Check that the outlet to which the control unit is connected is receiving electricity.
  2. Disconnect the control unit and wait at least 20 seconds before reconnecting. If the problem persists, contact Polaris Technical Support at 1-800-822-7933 (USA)
No user action required. The pause does not affect the overall cleaning cycle.